空氣壓縮機使用時注意事項： Precautions for the use of air compressor: 1 檢查各部螺絲或螺母,是否有松動現象； 1 check whether screws or nuts are loose. 2 皮帶松緊是否適當； 2 belt looseness is appropriate or not; 3 管道是否正常,油位是否合適； 3 whether the pipe is normal and the oil level is suitable. 4 電線及電器開關是否合乎規定，界限是否正確； 4 is the wiring and electrical switch properly regulated and the limits are correct? 5 各輪腳支點是否已 或固定平穩； 5 whether or not the pivots of each foot have been or fixed. 6 壓縮即皮帶輪是否輕易以手轉動； 6 compression is whether the pulley is easily rotated by hand. 7 壓縮機工作前,最好空轉2到3分鐘以上,再正常操作； 7 before the compressor works, it is best to idle for more than 2 to 3 minutes, and then operate normally. 8 檢查運轉方向是否和指示箭頭指者相同,若不相同時,三相馬達請將三條電源中任意兩條對換即可； 8 check whether the direction of operation is the same as that of the indicating arrow. If not, the three-phase motor can replace any two of the three power supply. 9 空氣清器要經常檢查是否有污染附著,過濾棉要常取下清洗(用氣油)或更 9 air cleaner should always check whether there is contamination or adhesion. 換,以保持良好的空氣過濾效果； Change, in order to keep good air filtration effect; 10 每日于空氣壓縮機檢查井鋼模具 隔離墩模具 隔離墩鋼模具 流水槽模具 U型槽模具 螺桿啟閉機 卷揚式啟閉機 銅雕佛像 使用后,應旋開桶排污閥,將桶內所凝積水分及油污等,排除干凈； 10 every day after the air compressor is used, the bucket drain valve should be unscrewed to clean up the water and grease in the bucket. 11 空氣壓縮機缸頭及銅管部分,因空氣壓縮而發熱,一般溫度均很高,這是必然現象并非異狀； 11 air compressor cylinder head and copper tube parts, due to air compression and fever, the general temperature is high, this is the inevitable phenomenon is not abnormal. 12 空氣壓縮機在運轉中若逢停電或使用后,務請將電源切斷,以確保安全。 12 If the air compressor is in power failure or use after operation, please cut off the power supply to ensure safety.